rahshad

FA

SUB-LINE INSULATION PIERCING CONNECTOR

SKU: IPC30
category: ABC Cables Accessories, Insulation Piercing Conncetors, Utility Networks Offers Accessories & Solutions

APPLICATION

  • This connector is used to establish LV branch of sub-lines from aerial bundled cable and is a type of bi-metal connector.
  • This connector can be connected to aluminum and copper cables (in both main and sub states).
  • There is no need to strip the cable for branch installation (in both with and without power flow).
Share this article :

TECHNICAL SPECIFICATIONS

Cross section of aerial bundled cable’s messenger Branch cable Conductor type of connectable cable 25- 50 mm2
25-70 mm2 16-70 mm2 Aluminum-Copper 2×14 Nm

 

PARTS AND COMPONENTS

Exterior body (main): including two parts of the base and the insulated upper shell made of UV and weather resistant fiber reinforced polyamide materials.

Conductive metal (Teeth): Plated conductive metal alloy (Other metal alloy and plating types are available upon request)

Sealing gasket: UV and weather resistant rubber materials impregnated with moisture resistant grease

Bolt: M8 Galvanized steel bolt

Nut and washer: Galvanized steel

 

INSTALLATION METHOD

First, unscrew the two connector screws and separate the base and the insulated upper shell. Place the aerial bundled cable on the teeth. Insert the branch conductor wire from the desired side through the insulated upper shell up to the end of the cable end cap. Then place the insulated upper shell on the base and fasten the screws to fully connect the connector to the branch conductor wire. To prevent rotating the connector while tightening the bolt, 17 mm boxing wrench can be used in boxing.

PACKAGING

60 PCS/CTN

Reviews

There are no reviews yet.

Be the first to review “SUB-LINE INSULATION PIERCING CONNECTOR”

Your email address will not be published. Required fields are marked *

Related Products

error: Content is protected !!