TECHNICAL SPECIFICATIONS
Branch cable cross section |
Branch cable conducting type |
Tightening torque of socket set screw |
AL (10-35) |
Aluminium |
15 Nm |
CU 8 (1.5-25) |
Copper |
PARTS AND COMPONENTS
Exterior body |
Including the body, the cable end cap and the insulated upper shell and made of plastic insulating materials and UV and weather resistant rubber materials. |
Interior body |
Hardened metal alloy |
Socket set screw |
Plated brass |
Moisture resistant grease |
To prevent corrosion, moisture resistant grease has been used inside the sub branch installation cavity. |
INSTALLATION METHOD
First, connect the sub-line insulation piercing connector type of IPC30 or IPC31 to the aerial bundled cable according to the installation method and place the insulated rod of multi-tap insulation piercing connector in sub branch place of sub-line insulation piercing connector and fasten the connector nut (according to the figure). Then open the insulated upper shell of multi-tap insulation piercing connector and according to the required number of branches, unscrew from 1 to 8 pcs of socket set screw. Afterwards, according to the output path, cut the branch cable and route the cable with the cover from the channel into the connector and tighten socket set screw and then close the insulated shell.
Important: Insulating gloves shall be used to install multi-tap insulation piercing connector (in case of electrical power current).
PACKAGING
40 PCS/CTN
Reviews
There are no reviews yet.