Low voltage dead-end clamp

SKU: DCL13-16

category: Dead End Clamps, Utility Networks Offers Accessories & Solutions

APPLICATION

This clamp is applied to the end of the grid and angles less than 90 degrees or greater than 180 degrees. For these angles, other clamps cause cable fatigue at the angle. For this purpose, tension clamp is used with a pigtail bolt at the end stand.

Share this article :

TECHNICAL SPECIFICATIONS

Product code	Mechanical connection type	Cross section of aerial bundled cable’s messenger (mm²)	Messenger type	Cross section	Max. breaking load(KN)
DCL13	Wire	16-35	Steel	25	18
DCL13	Wire	16-35	Aluminium	35	14
DCL14	Wire rope	16-35	Steel	25	18
DCL14	Wire rope	16-35	Aluminium	35	14
DCL15	Wire	50-70	Steel	50	15
DCL15	Wire	50-70	Aluminium	70	20
DCL16	Wire rope	50-70	Steel	50	15
DCL16	Wire rope	50-70	Aluminium	70	20

PARTS AND COMPONENTS

Body	Integrated aluminum with a special alloy to increase tensile strength
Wedge	Including two tongue and groove parts which slides within the body and is made of UV resistant fiber reinforced polyamide.
Wire rope or wire	Made of galvanized steel which has a very high tensile strength. The wire rope is secured to the dead end clamp body by rivets. Also, the plastic protector is located in the center of the wire rope arc, so that it can give more lifetime and strength to the clamp at the connection point of the wire rope to the pigtail bolt hook.

INSTALLATION METHOD

First, pull the clamp wedges out from inside the body so that the relevant messenger can be inserted inside. Then push the wedges back into the body.

Now, depending on the type of clamp restraint, which is a wire rope or wire, attach the restraint to the pigtail bolt. For the wire rope, it is necessary to connect the pigtail bolt in the plastic place of the wire rope. In case of wire restraint, make sure that the end nut of the wire is tight to the clamp