rahshad

FA

End-user insulation piercing connector

SKU: IPC10
category: Insulation Piercing Conncetors, Utility Networks Offers Accessories & Solutions

APPLICATION

  • This connector is used to establish LV branch of subscriber cable from aerial bundled cable and is a type of bi-metal connector.
  • This connector can be connected to aluminum and copper cables (in both main and sub states).
  • There is no need to strip the cable for branch installation (in both with and without power flow).
Share this article :

TECHNICAL SPECIFICATIONS

Aerial bundled cable
cross section		 Branch cable cross section Conductor type of connectable cable Tightening torque of bolt
16-70 mm2 16-70 mm2 16-70 mm2 16-70 mm2

 

PARTS AND COMPONENTS

Exterior body(main): including two parts of the base and the insulated upper shell and made of UV and weather resistant fiber reinforced polyamide materials.

Conductive metal (Teeth): Plated conductive metal alloy (Other metal alloy and plating types are available upon request)

Sealing gasket: UV and weather resistant rubber materials impregnated with moisture resistant grease

Bolt: M8 Galvanized steel bolt

Nut and washer: Galvanized steel

 

INSTALLATION METHOD

First, unscrew the connector screw and separate the base and the insulated upper shell. Place the aerial bundled cable on the teeth. Insert the branch conductor wire from the desired side through the insulated upper shell up to the end of the cable end cap. Then place the insulated upper shell on the base and fasten the screws to fully connect the connector to the branch conductor wire. To prevent rotating the connector while tightening the bolt, 18 mm boxing wrench can be used in boxing.

PACKAGING

120 PCS/CTN

Reviews

There are no reviews yet.

Be the first to review “End-user insulation piercing connector”

Your email address will not be published. Required fields are marked *

Related Products

error: Content is protected !!