Insulation piercing connector

APPLICATION

  • This connector joins low voltage copper cable to aerial bundled cable network.
Share this article :

TECHNICAL SPECIFICATIONS

Model Copper cable cross section Aluminium cable cross section Weight (gr)
IPC 50 CU 16~185 AL 35~200 340
IPC 52 CU 10~95 AL 25~150 160
IPC 54 CU 6~50 AL 16~70 130

 

PARTS AND OMPONENTS

Plastic body Including two UV and weather resistant upper and lower parts
Main Conductor Including two upper and lower parts made of corrosion and weather resistant aluminium alloy
Copper plate A copper plate that is placed on the upper and lower sides of the main conductor by a special resin polymer which  prevents the corrosion of conductor
Bolt, nut and washers Hot-dip galvanized steel

INSTALLATION METHOD

First, cut the input and output ports of the plastic body with a cutter according to the cross section area of the copper and aluminum cables.

After stripping the aerial bundled cable, remove the locking appendages of the lower body from the place in the upper body by pushing it down and out.

In this way, the plastic body of the connector is opened, but it is not separated by the arrow-shaped restraint. This makes it easy for line worker to continue working.

After that, remove the main conductor from inside the plastic body and unscrew the upper screws using a suitable wrench counter clockwise. Carefully clean all connecting surfaces with a wire brush.

Then, apply moisture resistant grease to the joints. Choose the special location of the cable depending on whether it is aluminum or copper. The length of the cable inside the connector should not be less than 50% of the seat. Tighten the main conductor screws. The upper and lower sides of the plastic body are located at the top and bottom of the main conductor and put the locking appendages of the lower body in the place in the upper body.

Finally, we restrain the connector in such a way that when snow and rain fall, the least possibility of water entering the part is provided.

The use of low pressure insulation gloves is mandatory throughout the installation process.

 

PACKAGING

50 PCS/CTN – IPC50

64 PCS/CTN – IPC52

100 PCS/CTN – IPC54

 

Reviews

There are no reviews yet.

Be the first to review “Insulation piercing connector”

Your email address will not be published. Required fields are marked *

Related Products

error: Content is protected !!